Search

cruisair-pilot-house-defroster

Seawater-Cooled Condensers With Reverse-Cycle Heating

Description

R Type remote condensing units are the next generation of seawater-cooled, reverse-cycle heat pumps for cooling and heating in marine applications. Small R Type units are available in capacities from 5,000 to 16,000 BTU/hr.

These condensing units can be installed with up to two Cruisair cooling units, where the total capacity is equal to the condensing unit capacity. In the cooling mode, full performance is available in seawater up to 90°F (32°C). In reverse-cycle heating, they will provide heat in seawater as low as 40°F (4.4°C).

R Type condensers have a number of improvements over the original “F” type condensing units. A one-piece chassis/pan has a smaller footprint, with two 1/2 in. FPT drain connections. New holddown brackets secure all four corners and allow for easier installation and removal. The one-piece electrical box with 3 ft. (0.9 m) cable can be remotely mounted. (RN models have a secondary box). Additional service ports have been added for ease of charging and servicing. The R type unit is designed as a drop-in for the older F and J type with few modifications.

Type R models are designed for installation in the vessel’s engine room or other mechanical space. It is not affected by moisture, normal vibration, or ambient temperatures up to 140°F (60°C). No ventilation is required.

Three different models are available, depending on what type of control is desired. “R” use the SA3 3-knob rotary switch assembly, “RX” is controlled by the SMX II microprocessor, and “RN” uses the SMX Net. SMX models include the respective SMX II or SMX Net power/logic boards. In addition, an SMXir or the new SMXht keypad/ display, a CXP connecting cable, and a TSEP temperature sensor must be purchased separately. If networking RN units, CNP network cables are also needed.

A seawater cooling system, with pump, scoop type through-hull, seacock, strainer, and overboard discharge, is also required.

Key Benefits

  • Service ports on refrigerant lines and base valves.
  • Compressor vibration-isolation mounts minimize noise and vibration.
  • Condensate drain pan with front and rear drain stems.
  • Corner mounting brackets for easier installation.
  • High-pressure switch (SMX control models also include low-pressure switch).
  • Electrical box can be mounted remotely.
  • Environmentally safe R-417A refrigerant.
  • Ignition protected.
  • Additional vibration isolation kit available.
  • Charged, tested, and leak checked at the factory.